Selva CAPRI - S95 Specifikace stáhnout pdf (Strana 14)

Check of the supply.

When you receive your motor, check that:

- the packing is integral

- the supply corresponds to the detailed list:

1. the entire motor

2. fuel tank supplied complete with the fuel hose and fast fuel joint (

for the motors with separate fuel tank )

3. tool-bag

4. use and maintenance manual

5. certificate of guarantee

6. list of our dealers and our after-sales service

7. declaration of conformity E.E.C.

- that there is no evident damage. If there is a damage or if parts are

missing, you must inform immediately and in detail the forwarding-

agent, SELVA joint-stock CO. or its area agents.

Picture No. 34

Outboard motor mounting

A good position of the motor on the transom is very important to

have an appropriate trim angle and therefore to obtain a good

performance from your boat

To have the optimum mounting height of the outboard motor, you must

mount it so that the anti-cavitation plate is between the bottom of the boat

and a level of 2 cm below it and it is parallel to it.

If the mounting-height is too high, cavitation tends to occur and

consequently there will be a falling-off in the performance and

a probable overheating of the motor.

If the mounting-height is too low, the water-resistance will

increase and thereby reduce engine efficiency.

Picture No. 35.

The motor must be vertical to the water surface and the bracket

mounted on a flat even surface and should be fully supported

by the top edge of the transom.

If the bracket is not fully supported or, if the transom height is

too low, a hard wood block should be securely fitted between

the bracket and the transom.

Picture No. 36.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 32 33

Žádné komentáře

Selva CAPRI - S95 Specifikace Strana 14